Features:
-
Application: Bonding
-
Material Compatibility: Thermoplastic
-
Acrylic Type: Acrylate
-
Multi-Part Adhesive: One-Part
-
Curing Method: UV Cure
-
Color: amber
-
Product Form: Liquid
-
Package Type: Bottle
-
Package Size: 1L
-
General type
-
impact resistancevibration
-
bonding material widely
-
Maximum Operating Temperature: +300 °F
-
can use ultravioletactivatorsboth
-
can be cure in seconds when use purple line
3. Typical Use:
This product is cured when exposed to UV radiation of 365nm. To obtain a full cure on surfaces exposed to air, radiation at 250nm is also required. The speed of cure will depend on the UV intensity as measured at the product surface.
Heat Cure
This product may be cured with heat. The bond area should be heated to 121°Cmaintained at that temperature for 30 minutes.
Activator Cure
Apply Activator 7075™ to one surfacethe adhesive to the other, mateclamp. The assembly will reach handling strength in approximately 4 minutes if the gap is small, full cure in 72 hours
Typical Properties of Cured Material
Cured @ 100 mW/cm², measured @ 365 nm, for 30 seconds per side plus 24 hours @ 22 °C.
